#52. Exhibit: In the figure shown, the customer requires that Caller ID for calls from the PSTN to the IP Phones must be supported. Analog trunks are equipped to the PSTN from both GWs. What is the correct voice GW design for this customer? (Note: Assume the PSTN CO switch is capable of delivering Caller ID on the connection to the Cisco voice GW, and the cisco voice gateway is using a VIC-2FXO-M1 card)
#55. When troubleshooting an IOS Voice Gateway, what command will produce detailed information (codec, ERL, tx/rx packets, dial peers, etc) on currently active calls?
#58. Exhibit: In the figure shown, the customer requires that Caller ID be displayed for all phones connected to the PBXs, and for calls in both directions across the IP network. The PBXs have only analog (FXS, FXO and E&M) capabilities to connect to the Cisco voice GWs. What design will achieve the customer’s requirements?